Reusable wood sponge can clean up oil spills

Scientists have developed reusable sponges made from wood that can soak up oil spills from water bodies.

Although oil and water don't mix, separating and recovering each component can be challenging.

The material, developed by researchers at the Chinese Academy of Forestry, selectively absorbs oil, and can be squeezed out and used again.

Over the years, scientists have developed numerous techniques to clean up oily water. However, many of these methods suffer from limitations, such as low efficiency, secondary pollution and high cost.

More recently, researchers have explored 3D porous materials, such as aerogels or sponges, based on various building blocks including synthetic polymers, silica or cellulose nanofibers.

However, these are often difficult to fabricate, lack mechanical robustness or are made from nonrenewable, nondegradable materials.

Xiaoqing Wang and colleagues from Chinese Academy of Forestry wanted to develop a sponge made from wood -- a renewable resource -- that would absorb oil and tolerate repeated squeezing without structural failure.

The team made the wood sponge by treating natural balsa wood with chemicals that removed lignin and hemicellulose, leaving behind a cellulose skeleton.

They then modified this highly porous structure with a hydrophobic coating that attracted oil, but not water. When placed in a mixture of water and silicone oil, the wood sponge removed all of the red-dyed oil, leaving clean water behind.

Depending on the oil tested, the sponge absorbed 16 to 41 times its own weight, which is comparable to or better than many other reported absorbents.

The sponge could endure at least 10 cycles of absorption and squeezing. The researchers incorporated the wood sponge into an oil-collecting device in the lab that continuously separated oils from the water surface.