A specially prepared carbon foam can help detect neutrons emitted by radioactive materials, which is key to counter-terrorism activities, workplace safety and industry, scientists say.
Christopher Lavelle of the Johns Hopkins University Applied Physics Laboratory and colleagues have successfully shown that boron-coated vitreous carbon foam can be used in the detection of neutrons emitted by radioactive materials.
Detecting neutrons is key to counter-terrorism activities, such as screening cargo containers, as well as other vital applications in nuclear power instrumentation, workplace safety and industry.
The demand for detectors has risen dramatically over the past decade while at the same time the usual detection material, helium-3, has become harder to obtain.
An advantage of the approach is that boron is abundant and relatively low cost compared to helium-3.
The use of a coated foam, in particular, disperses the boron evenly throughout the detector volume, increasing efficiency by filling in otherwise empty space.
Lavelle and his colleagues' work builds on a series of experiments conducted at National Institute of Standards and Technology (NIST) and the University of Maryland that had demonstrated that a process called noble gas scintillation can be controlled and characterised precisely enough to detect the neutrons emitted by radioactive materials.
Scintillation refers to a process where energetic particles produce flashes of light when passing through certain materials, in this case xenon gas.
Sensitive light detectors record the rate at which these light flashes occur to measure the presence and intensity of neutrons in the environment.
In a follow-on experiment, the research team obtained samples of "carbon foam" coated with boron carbide and placed them in xenon gas.
The boron-10 isotope in the coating readily absorbs neutrons. Following neutron absorption, energetic particles are released into the gas and create flashes of light.
In this experiment, researchers determined that neutrons captured deep within the coated foam produce large enough flashes to be detected by light detectors outside the foam.
Previously, there had been some doubt as to whether the light flashes would actually escape foam, or if the foam would completely shadow them from the light detector.
The next steps in the series of experiments include investigating other unique detector geometries, such as multiple layers of boron-coated thin films, the use of optically transparent neutron absorbers, and finalising a design for a potential prototype detector.
The study was published in the journal Applied Physics Letters.
